I have some black overspray on the roof of the white estate, i have tried t-cut but its not shifting, any ideas how i can get it off without removing...
Last post
I have used Farecla, G3, G5, G10. The hardest is good for using by hand, just spray a little bit of water when it gets dry while grinding to make it...
Can anyone advise me if my k reg ' meteor' 1.9 flat diesel estate is the bottom level trim & if so are they rare ?
Manual sunroof
No interior...
Last post
Can't comment on trim spec but as for rarity, I looked at howmanyleft.co.uk, and learned that at autumn 2016,there were 6 BX19 TGD Meteors. That is,...
Hi just seen eBay item 162448975378 and would be grateful if you could offer your views on it including what's a fair price also are gti alloys easy...
Last post
Mines a GTi auto but without the auto. I put in a manual box to get more performance and economy and I think it suits the GTi better unless of course...
Just wondering if any one has any experience of repairing the strips on the rear window. Or of any companies that sell new heated strips as mine are...
Dual mass flywheels, what's the point?
I have just spent the last few days changing the DMF on the Relay Van, one of the springs or dampers had broke...
Last post
They're there to soften the interface between foot and road. They also dampen out a lot of the vibration from diesel engines and act as a harmonic...
I have here my daughters 09 plate Suzuki Swift 1.3 petrol which has suffered the very common issue of the 1st motion shaft bearings failing, this a...
Last post
I would have liked the Swift Sport, but having a test drive after the BX there was no contest. The standard car was much more comfortable and I think...
Help!
would someone be kind enough to let me know which other car alloys will drop straight onto my 16TRS meteor.
I understand 4x108 and 5.5 J, but...
Last post
It will depend on the offset – many with the correct 108mm BCD 4stud fitting have an offset which is far too much for the BX – if they are specified...
I use my BX as my daily drive and although I love driving it, I have been wondering lately what's going on underneath with all this salt on the...
Last post
I think covers are bad as they can make the car sweat if covered up with a warm engine encouraging more rust, and if you live in a windy area like I...
Can anyone recommend a local chap to Edinburgh where I can get my diesel bx worked on ( no problems with car , just looking for someone who knows...
Last post
There aren't many Citroen specialists in Scotland unfortunately. I know a chap who travels to Welwyn Garden City to have work done on his cars. What...
I want to fit some rear speakers in the estate but dont want to cut holes in the parcel shelf or use the original mounted units as they are rubbish,...
Last post
Something I've toyed with is to blank off the boot side cubby holes, and fit some better speakers in there. That way you're not cutting difficult to...
I have been driving a BX 14 for the last 10 years, and would like to know if more petrol is used if you descend a long hill in gear (on the overrun)...
Last post
Speaking as someone who does know the TU3 very well, it's pointless. I mean, really pointless. Economy and power both almost identical in healthy...
Hello all, Not sure if that's what its called its the panel
that meets the rear bumper mines coming off just had it replaced
to, DIY so what do I...
Last post
You can try warming the bonding up with a heat gun to soften it sometimes makes it a bit easier to get them off, carefully does it or it will crack,...
My til now reliable Wolf/Rockworth 24Litre compressor has a problem, the pressure will only go up to 35-40psi and wont rise any higher, it runs fine...
Last post
Ok thanx for that, i have removed the head and piston, the piston seems to have just one non metal-almost a hard plastic type piston ring which looks...
Hi everyone, Would one of these look ok
on my valver I know it will make tail gate boot heavier
not sure . What do you guys think.
8) 8)
Last post
I'm pretty sure I wont bother with one.
Good call. A classic example of cheap-looking 'go faster' bling. I don't think they have many fans, and with...
Need some paint for the estate, all i can find is a small sticker on the n/s inner wing with UA1 on it, is the the colour code? The car is white but...
Last post
Ok, so we have established the paint code is EWT, so what does UA1 represent? Just out of interest. This is on a small white sticker approx an inch...
Hi guys, I've been told the 4 digit code in the passenger door indicates my cars birth date, mine is 5328, can anyone tell me what it is and how you...
Last post
Maybe it would of been interesting if it was made a year before it was registered or my birth date, or a date that's means something personally to me.
West Bay Valver Returns!
It was my spares that saved the car! :D :)
Last post
Weird - there are two threads running on this! As I said on the other one, looks a very good job - better than many I've seen on here. No worries on...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
