Little tip for seatbelts that are slow to retract, get some silicone spray £3.99 from halfords then remove the trims from the seatbelts and pull out...
My height selector lever has always been heavy to move, particularly for citaerobics, but since fitting a new accumulator sphere, its impossible to...
Last post
The ride is superb now, Stewart, but it feels as if there is pressure - rather than in the lever - I've looked underneath and your magic lube mixture...
Having heard that BX`s will start and run on vegetable oil can someone please explain in laymen`s terms how this works?
I`m told that chip shops can...
Last post
Apart from running a motorbike once on Avgas and acetone, when I was much younger .
Interesting, we used to produce Acetone where I work but like...
I'm about to remove the sunroof to get at rust on the frame. Any snags to beware of, and which might necessitate re-alignment on refitting?
BOL says...
Last post
I've dropped the roof-liner frequently to clear pine needles from the drain channel. The glass IS very heavy, but I've found it best to place a...
Tom mentioned recently getting 55mpg after fiddling with his motor. Anyone able to give me an idiot's guide to turning down the fuelling on...
Last post
I once ventilated the standard black plastic airbox on my old TD BX, I peppered it with inch and a quarter holes, to my mind the thing did breathe a...
OK, here's tha story. I have a 43,000 mile old TGD but it is a 1.9.
I want to upgrade it by reshelling my TZDT into it. How do I go about the legal...
Last post
I think that my credentials as a member are sufficiently established. A membership certificate is all we require, I'm sure that Jon would run one up...
The heater control dial on the dashboard on my 1.9 diesel estate is playing up. It`s quite hard to move and clicks round rather than going smoothly....
Last post
Whatever you do, don't bust the pipes that go through the firewall as they are NLA.
I've had a few argue that they can be bought, until they try and...
An interesting quirk has appeared on my BX since its returnto the road. when i brake, e.g approaching a set of traffic lights, and reach a standstill...
Last post
That was a fairly flippant remark. Nitrogen does diffuse through the membrane but the most likely culprits will be our old favourite the Doseur valve...
How easy is rust proofing a car, from the viewpoint of a complete novice,,,,, hehe. I've seen this underseal 'paint' in halfords which is supposed to...
Last post
Mate of mine is restoring this:
and says that the blokes at the local Morris club swear by Sunflower Oil.
My BX14 has developed a slight oil leak from the bottom of the engine. It makes little to no difference to the oil level, which is checked regularly,...
Last post
Well I was hpoing that it wouldn't need a new engine as its only coverd 70,000 miles with a full history. I'll get a mechanic mate to have a...
Hey, been tinkering tonight again with the 16v, was supposed to be doing the CV boot but ive noticed the bottom rubber thing above the lower ball...
Last post
I get a bit of this with mine occasionally and in my case it's oil and as I use a full synthetic, it doesn't seem to smell like the old mineral stuff...
I hope I'm being paranoid again but tonight Rene decided to stop using brake lights so now I can't tell people I'm stopping. I checked the bulbs and...
Last post
The RAC bloke bridged the wires and nothing.
I have booked an auto electrician to come round tomorrow. And as luck would have it, the only one that...
F* $%ng b*ll&%ks. Wound the (electric) passenger window down on my estate and it won`t go back up. Three and half hours later it`s now wedged in with...
Last post
Where straight-feed 12v motors on the BX are concerned, I nowadays tend to go for the jugular: disconnect them and then use my trusty booster pack...
hi , could anyone please tell me where i can find the paint code of my bx ???? its a white bx16v , 1989 , g reg , anyone know which name is given to...
Last post
have used bmw alpine white for the front bumper and it matches pretty well :D , probably as good a match as i will get 8)
Hi can anyone give me any ideas my suspension works fine no problems no leaks etc but when i set the lever inside to the intermidiate position ( the...
The young fella's TZi started doing strange things the other day, so I eventually took a long look, tried the easy options and came to the conclusion...
Last post
Strange thing - my neighbour catches me changing the oil on the ZX and tells me about some vehicle he had with the XUD engine - all burn loads of oil...
Engine dies a few seconds after firing, but if eventually gets going (but lumpily) if I keep the revs slightly up. It also seems to have lost some of...
Last post
Think im in general agreement that it's fuel starvation! Change the fuel filter and see what happens, it's just possible that its the fuel pump with...
..when I jacked my BX up (under the o/s/f subframe) there was a sort of explosion noise from under the bonnet and a large amount of LHM has thrown...
Last post
My favourite comes from the security valve (on top of the crossmember N/S wheelarch rear) goes from rubber to plastic and then runs across the top of...
i thought the link on the Xantia was only an intermediary link? the ball joint on the corrector is still the same witht he plastic pivot bit between...
Been on the LHM pipe job most of the day now and I`ve just discovered I`ve pulled one of the pipes off which goes under the engine somewhere just...
Last post
Cheers Stewart. I think I`ll let my local garage have a go at it and get them to fit the new pipe properly whilst they`re there. I`ll have to get him...
Had a bit of a mere today. I swapped over the struts and spears from Marty's old BX to try and make the suspension as smooth as I found Martys to be....
Last post
Dave -
The idea is that the outer cylinder rod gets a kind of wear pattern from the up/down sliding in the slide bush.
If this wear pattern is...
....I also have 165-70-14`s on my diesel on standard rims. Being an ex-tyre fitter I should probably know this but how much difference would it make...
Last post
The reason for remoulds going on the front is to increase understeer by biassing the grip to the back. Apparently it is safer than oversteer.
The...
I`m going to replace the fuel filter today on my diesel BX. Will I have to bleed the system after replacing it or are they self bleed? I was thinking...
Last post
i have the top halfs of one of those canisters with the button on it in the garage if its any use? may have the canister as well but i think its only...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
